In the plastic processing industry, products appear shrinkage, crazing, bubbles, cracking, flow marks, poor transparency and other phenomena. The main reason for these poor quality is that the plastic is not fully dried before it is formed, and the dehumidification dryer is to fully dehumidify and heat the air in a closed circulation system, The dry air quickly separates the moisture in the plastic particles to achieve the effect of dehumidification and drying. What are the maintenance methods of pet dehumidification dryer? The following is a short series of aoshide to introduce you.

What are the maintenance methods for pet dehumidification dryer:

1. Pay attention to the place of placement and use, and do not use it in too closed and narrow space. If there are objects or walls around, it should also be kept at a distance of more than 50 cm. And do not use it in places with a lot of oil smoke, otherwise it may cause the loss of the function of the heat exchanger.

Dehumidification dryer

2. The dehumidification dryer is suitable for indoor temperature, which is about 12 ℃ ~ 35 ℃. The function of the dehumidifier is the best time to play. If the room temperature is lower than 12 ℃, the humidity in the air is usually very low. In order to avoid physical discomfort caused by excessive drying, it is recommended that you do not use the dehumidifier.

3. For the cleaning of pet dehumidification dryer body, when dealing with the cleaning problem of industrial dehumidifier, you must use neutral detergent, or directly wipe the dehumidifier with a soft wet rag. Too stimulating detergent will cause varying degrees of damage to the body.

4. Do not start the pet dehumidification dryer immediately after it is shut down. After it stops running, it must wait three minutes before it can be started again, so as to prolong the service life of the compressor. At present, the new dehumidifier has the function of self-protection. Therefore, if you press the start button immediately after shutdown, it may not work. This is a normal phenomenon.

The above content is an introduction to the maintenance methods of pet dehumidification dryer. The hot and humid air returned from the drying bucket is cooled and blown into the honeycomb runner. The moisture in the air is adsorbed by the runner and then desorbed by the regenerative heating air. Two streams of air act on the runner at the same time, and with the rotation of the runner, the water in the air is continuously adsorbed and desorbed by the regenerated air to form a stable low dew point air, which is heated to the drying temperature of the plastic and blown into the drying barrel to form a closed cycle and dry the raw materials.